[
{ type: install
  message: <<EOM
syslog-ng is now installed!  To replace FreeBSD's standard syslogd
(/usr/sbin/syslogd), complete these steps:

1. Create a configuration file named %%PREFIX%%/etc/syslog-ng.conf
   (a sample named syslog-ng.conf.sample has been included in
   %%PREFIX%%/etc). Note that this is a change in 2.0.2
   version, previous ones put the config file in
   %%PREFIX%%/etc/syslog-ng/syslog-ng.conf, so if this is an update
   move that file in the right place

2. Configure syslog-ng to start automatically by adding the following
   to /etc/rc.conf:

        syslog_ng_enable="YES"

3. Prevent the standard FreeBSD syslogd from starting automatically by
   adding a line to the end of your /etc/rc.conf file that reads:

        syslogd_enable="NO"

4. Shut down the standard FreeBSD syslogd:

     kill `cat /var/run/syslog.pid`

5. Start syslog-ng:

     %%PREFIX%%/etc/rc.d/syslog-ng start
EOM
}
{ type: upgrade
  maximum_version: "3.29.1"
  message: <<EOM
When upgrading from before 3.29.1 these variables, if used, should be replaced:
* syslog_ng_flags replaces syslog_ng_config (syslog_ng_config still works),
* syslog_ng_pidfile replaces syslog_ng_pid (syslog_ng_pid still works).
EOM
}
]